Nds gameboy macro shell8/28/2023 ![]() If you have 30 gauge kynar wire you can just use that, if not, remove the longer black and red wires connecting these two boards and solder them to the speaker as seen below. Remove the screws holding the two small boards in. ![]() Once these are all removed you can remove the shoulder buttons and lift the motherboard from the shell.Īfter the screws are removed pry the back of the screen off to reveal the inside. ![]() Do it slowly and softly, it is fragile (if you break it you can fix it with somewhat of a workaround). These two ribbon cables are removed by pulling the brown locking mechanism forward. Do not remove the motherboard yet, first lift up the bottom screen large ribbon cable to reveal two smaller cables below it. Once removed disconnect the Wifi antenna cable, and the ribbon cables marked in red. Once opened, remove the screws marked in red. Using the tri-wing screwdriver, removed the screws from the points marked in red below.Īfter the screws are removed simply lift the rear of the shell to reveal the innards of the DS.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |